Roland XV-5080. Owner's Manual page 95

81: GUITAR MULTI A
Guitar Multi 1 connects Compressor (Cmp), Overdrive or
Distortion (ODDS), Amp Simulator (Amp), Delay (Dly), and
Chorus or Flanger (CF) effects in series.
L in
Compressor
R in
Chorus/
Delay
Flanger
Feedback
Delay
Delay
Chorus/
Flanger
Feedback
Chorus/
Flanger
Chorus/
Flanger
* In this section, the Delay and Chorus/Flanger are depicted in
diagrams. When these same effects are discussed later, these
diagrams are used.
Overdrive/
Amp
Distortion Simulator
L out
Pan
R out
L out
R out
Chapter 2 Using the XV-5080 Effects
Sequence
Comp (Compressor Switch)
Turns the Compressor on/off.
OD/Dist (Overdrive/Distortion Switch)
Turns the Overdrive/Distortion on/off.
Amp Sim (Amp simulator Switch)
Turns the Compressor on/off.
Delay (Delay Switch)
Turns the Delay on/off.
Cho/Flg (Chorus/Flanger Switch)
Turns the Chorus/Flanger on/off.
Compressor
Attack (Compressor Attack)
Specifies the duration of the attack when sound is input.
Sustain (Compressor Sustain)
Specifies the time over which low-level sounds will be
boosted to reach the specified volume. Increasing the value
will shorten the time. When the value is modified, the level
will also change.
Level (Compressor Level) #
Sets the volume of the compressor sound.
Overdrive/Distortion
Type
Selects either Overdrive or Distortion.
Drive #
Adjusts the degree of distortion. The volume will change
together with the degree of distortion.
Tone (Overdrive/Distortion Tone)
Adjusts the sound quality of the Overdrive/Distortion effect.
Level
Adjusts the Overdrive/Distortion output level.
95