Pitch Shift - Roland XV-5080. Owner's Manual

Chapter 2 Using the XV-5080 Effects
21: TIME CONTROL DELAY
This effect allows you to use a specified controller (the
controller selected in EFX Control Source) to control the
delay time and pitch in realtime. Lengthening the delay will
lower the pitch, and shortening it will raise the pitch.
For details refer to "Changing the Multi-Effects Settings
From an External MIDI Device (p. 217)."
fig.2-27
L in
Time Control Delay
Feedback
R in
Delay
Time (Delay time) #
Adjust the time delay from the direct sound until when each
delay sound is heard.
Acceleration
This parameter adjusts the time over which the Delay Time
will change from the current setting to a newly specified
setting. The rate of change for the Delay Time directly affects
the rate of pitch change.
HF Damp
Adjust the frequency above which sound fed back to the
effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to BYPASS.
Feedback #
Adjust the proportion (%) of the delay sound that is fed back
into the effect. Negative (-) settings will invert the phase.
EQ Gain
Low (Low Gain)
Adjust the gain of the low frequency range.
High (High Gain)
Adjust the gain of the high frequency range.
Balance
Balance (Effect Balance)
Adjust the volume balance between the direct sound and the
delay sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
delay sound will be output.
56
2-Band
L out
EQ
Balance D
Balance W
Balance W
2-Band
R out
EQ
Balance D
Output
Level (Output Level)
Adjust the output level.
Pan (Output Pan)
Adjust the stereo location of the delay sound. L64 is far left, 0
is center, and 63R is far right.
22: 2VOICE PITCH SHIFTER
A Pitch Shifter shifts the pitch of the original sound. This 2-
voice pitch shifter has two pitch shifters, and can add two
pitch shifted sounds to the original sound.
fig.2-28
L in
Level Balance A
2Voice Pitch Shifter
Level Balance B
R in
Pitch A
Coarse (Coarse Pitch A) #1
Adjust the pitch of Pitch Shift A in semitone steps (-2-+1
octaves).
Fine (Fine Pitch A) #1
Make fine adjustments to the pitch of Pitch Shift A in 2-cent
steps (-100-+100 cents).
One cent is 1/100th of a semitone.
Pan (Output Pan A)
Adjust the stereo location of the Pitch Shift A sound. L64 is
far left, 0 is center, and 63R is far right.
Pre Delay (Pre Delay Time A)
Adjust the time delay from when the direct sound begins
until the Pitch Shift A sound is heard.

Pitch shift

Mode (Pitch Shifter Mode)
Higher settings of this parameter will result in slower
response, but steadier pitch.
Balance D
L out
PanA L
Balance W
PanA R
PanB L
PanB R Balance W
R out
Balance D