Roland XV-5080. Owner's Manual page 48

Chapter 2 Using the XV-5080 Effects
Level (High Frequency Level)
Adjust the volume of the high frequency rotor.
Output
Level (Output Level) #
Adjust the output level.
9: COMPRESSOR
The Compressor flattens out high levels and boosts low
levels, smoothing out unevenness in volume.
fig.2-12
L in
Compressor
R in
Compressor
Attack
Adjust the attack time of an input sound.
Sustain
Adjust the time over which low level sounds are boosted
until they reach the specified volume.
Post Gain
Adjust the output gain.
EQ Gain
Low (LowGain)
Adjust the low frequency gain.
High (High Gain)
Adjust the high frequency gain.
Output
Level (Output Level) #
Adjust the output level.
Pan (Output Pan) #
Adjust the stereo location of the output sound. L64 is far left,
0 is center, and 63R is far right.
48
L out
Pan L
2-Band
EQ
Pan R
R out
10: LIMITER
The Limiter compresses signals that exceed a specified
volume level, preventing distortion from occurring.
fig.2-13
L in
Limiter
R in
Limiter
Threshold (Threshold Level)
Adjust the volume at which compression will begin.
Ratio (Compression Ratio)
Adjust the compression ratio.
Release (Release Time)
Adjust the time from when the volume falls below the
Threshold Level until compression is no longer applied.
Post Gain
Adjust the output gain.
EQ Gain
Low (LowGain)
Adjust the low frequency gain.
High (High Gain)
Adjust the high frequency gain.
Output
Level (Output Level) #
Adjust the output level.
Pan (Output Pan) #
Adjust the stereo location of the output sound. L64 is far left,
0 is center, and 63R is far right.
L out
Pan L
2-Band
EQ
Pan R
R out