Roland XV-5080. Owner's Manual page 89

74: RHODES MULTI
Rhodes Multi provides Enhancer (EH), Phaser (PH), Chorus
or Flanger (CF), and Tremolo or Pan (TP) effects connected in
series.
fig.02-074m.e
L in
Enhancer
Mix
R in Enhancer
Mix
Chorus/
Flanger
Feedback
Chorus/
Flanger
Sequence
Enhancer (Enhancer Switch)
Turns the Enhancer on/off.
Phaser (Phaser Switch)
Turns the Phaser on/off.
CF Sw (CF Switch)
Turns the chorus/flanger on/off.
TP Sw (TP Switch)
Turns tremolo or pan on/off.
Enhancer
Sens (Enhancer Sens) #
Adjusts the sensitivity of the enhancer.
Mix Level (Enhancer Mix Level)
Adjusts the proportion by which the overtones generated by
the enhancer are combined with the direct sound.
Phaser
Mode (Phaser Mode)
Selects the number of stages in the phaser.
Manual (Phaser Manual) #
Sets the center frequency at which the phaser sound will be
modulated.
Resonance
Phaser
Mix
Tremolo/
L out
Pan
Tremolo/
R out
Pan
Chapter 2 Using the XV-5080 Effects
Mix Level (Phaser Mix)
Adjusts the proportion by which the phase-shifted sound is
combined with the direct sound.
Rate (Phaser Rate) #
Specifies the frequency of modulation.
Depth (Phaser Depth)
Adjusts the depth of modulation.
Resonance (Phaser Resonance)
Adjusts the emphasis for the region around the center
frequency specified by the PH Man parameter.
Chorus/Flanger
Type
Selects either Chorus or Flanger.
Rate
Specifies the rate of modulation.
Depth
Specifies the depth of modulation.
Feedback (Feedback Level)
Adjusts the proportion (%) of the flanger sound that is fed
back into the effect. Negative (-) settings will invert the
phase.
PreDly (Pre Delay)
Adjusts the time from the direct sound until when the chorus
or flanger sound is heard.
Balance #
Adjusts the volume balance between the direct sound and
the chorus/flanger sound.
Type (Filter Type)
Selects the type of filter.
OFF: No filter is used.
LPF: The frequency region above the Cutoff Freq setting will
be cut.
HPF: The frequency region below the Cutoff Freq setting will
be cut.
Cutoff (Cutoff Frequency)
Sets the cutoff frequency when a specific frequency band is
cut off by a filter.
89