Roland XV-5080. Owner's Manual page 78

Chapter 2 Using the XV-5080 Effects
Chorus
Rate (LFO Rate) #
Adjust the modulation frequency of the chorus sound.
Depth (LFO Depth)
Adjust the modulation depth of the chorus sound.
Phase
Adjust the spaciousness of the chorus sound.
Pre Delay (Pre Delay Time)
Adjust the delay time from the original sound until when the
chorus sound is heard.
Filter
Type
OFF:A filter will not be used.
LPF:The frequency region above the Cutoff Freq setting will
be cut.
HPF:The frequency region below the Cutoff Freq setting will
be cut.
Cutoff (Cutoff Frequency)
Sets the cutoff frequency when a specific frequency band is
cut off by a filter.
EQ Gain
Low (Low Gain)
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
High (High Gain)
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance
Balance #
Adjust the volume balance between the original sound and
the flanger sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W only the flanger sound
will be output.
Output
Out (Output Mode)
Adjust the method that will be used to hear the sound that is
78
output to the OUTPUT jacks. The optimal 3D effect will be
achieved if you select SPEAKER when using speakers, or
PHONES when using headphones.
Level (Output Level)
Adjust the output level.
61:3D FLANGER
This applies a 3D effect to the flanger sound. The flanger
sound will be positioned 90 degrees left and 90 degrees right.
fig.2-71
L
3D Flanger
R
Flanger
Rate (LFO Rate) #
Adjust the modulation speed of the flanger sound.
Depth (LFO Depth)
Adjust the modulation depth of the flanger sound.
Feedback #
Adjust the proportion (%) of the flanger sound that is to be
returned to the input. Positive (+) settings will return the
signal to the input with the original phase, while negative (-)
settings produce an inverted phase. Higher settings will
produce a more distinctive sound.
Phase
Adjust the spaciousness of the flanger sound.
PrDly (Pre Delay Time)
Adjust the time delay from the direct sound until the flanger
sound is heard.
Filter
Type
OFF:No filter is used.
LPF:The frequency region above the Cutoff Freq setting will
be cut.
HPF:The frequency region below the Cutoff Freq setting will
be cut.
Cutoff (Cutoff Frequency)
Sets the cutoff frequency when a specific frequency band is
cut off by a filter.
2-Band
L out
EQ
2-Band
R out
EQ