Roland XV-5080. Owner's Manual page 98

Chapter 2 Using the XV-5080 Effects
Cutoff (Cutoff Frequency)
Sets the cutoff frequency when a specific frequency band is
cut off by a filter.
Output
Level (Output Level)
Adjusts the output level.
Pan (Output Pan)
Adjusts the stereo location of the output sound.
83: GUITAR MULTI C
Guitar Multi C connects Overdrive or Distortion (ODDS),
Wah (Wah), Amp Simulator (Amp), Delay (Dly), and Chorus
or Flanger (CF) effects in series.
fig.02-083m.e
L in
Overdrive/
Distortion
R in
Chorus/
Delay
Flanger
Sequence
Wah Sw (Wah Switch)
Turns the wah on/off.
Amp Sim (Amp Simulator Switch)
Turns the Amp Simulator on/off.
Wah (Wah Switch)
Turns the wah on/off.
Delay (Delay Switch)
Turns the Delay on/off.
Cho/Flg (Chorus/Flanger Switch)
Turns the wah on/off.
Overdrive/Distortion
Type
Selects either Overdrive or Distortion.
Drive #
Adjusts the degree of distortion. The volume will change
together with the degree of distortion.
98
Amp
Wah
Simulator
L out
Pan
R out
Tone
Adjusts the sound quality of the Overdrive/Distortion effect.
Level
Adjusts the Overdrive (or Distortion) output level.
Wah
Filter Type (Wah FIlter Type)
Selects the filter type.
LPF: The wah effect will be applied over a wide frequency
range.
BPF: The wah effect will be applied over a narrow frequency
range.
Rate
Adjusts the frequency of the modulation.
Depth
Adjusts the depth of the modulation.
Sens
Specifies the sensitivity with which the filter will be affected.
Manual #
Sets the center frequency from which the effect is applied.
Peak
Adjusts the amount of the wah effect that will occur in the
area of the center frequency. Lower settings will produce a
wah effect in a broad area around the center frequency, and
higher settings will produce a wah effect in a narrower area
around the center frequency.
Amp Simulator
Type (Amp Simulator Type)
Selects the type of guitar amp.
Small: small amp
BltIn: built-in type amp
2-Stk: large double stack amp
3-Stk: large triple stack amp
Delay
Left Time (Delay Time Left)
Adjust the delay time from the original sound until the left
delay sound is heard.
Right Time (Delay Time Right)
Adjust the delay time from the direct sound until the right
delay sound is heard.