Table of Contents
Advertisement
Installer
Programming
Menus
Note
The CID format only supports
account numbers with letters A
through F, or numbers 0
through 9 (or a combination of
those letters and numbers).
Installer Programming Menus
This section guides you through the installer programing menus. There are three tiers of pro-
gramming menus. Tier 1 menus are accessible immediately after entering program mode. Refer
to Table 1 on page 5 for information on navigating the programming menus and Appendix C for
a diagram of all programming menus.
Entering Installer Programming Mode
Entering programming mode on site is done from the panel, using an installer code. The default
installer code is 4321. The system can be put into program mode only when the system is dis-
armed.
¾
To enter programming mode:
With the system disarmed, press 8 + code.
Account Menu (1st Tier)
The account menu lets you set up the account number used for customer identification by the
central monitoring station.
ACCOUNT (1st Tier)
Default = 00000, Parameters = 4-10 digits; 0-9, A-F)
The account number is used as panel (or customer) identification for the central monitoring sta-
tion. The panel sends the account number every time it reports to the central station. Account
numbers must be 4 to 10 characters long.
Alpha characters A–F can be assigned to the account number by pressing and holding buttons
1–6 respectively, until the character appears.
¾
To program an account number:
Š Press #, then enter the 4-10 digit code (0-9 and A-F) and press #.
Phones Menu (1st Tier)
The PHONES menu lets you set up central station reporting for the Allegro system.
Phone 1 and Phone 2 (2nd Tier)
Each 2nd tier PHONE menu contains the following 3rd tier menus:
•
NUMBER 1 and NUMBER 2
•
FMT - CID
•
HIGH LVL
•
LOW LVL
•
OPENINGS
•
CLOSINGS
•
BACKUP (Only under PHONE 2.)
(ACCOUNT—)
7
Hide quick links:
Advertisement
Table of Contents
