Connecting Detection Devices To Panel Zone Inputs; Connecting Intrusion Detection Devices; Connecting The Ac Power Transformer; Connecting The Backup Battery Pack - GE 60-874-95R Installation Instructions Manual

Note
In Canada, use the AC
power transformer without a
securing tab, (part no. 22-
117-CN).
4

Connecting Detection Devices to Panel Zone Inputs

Zone input is supervised using a 2 k Ohm, end-of-line (EOL) resistor (included with panel) at the
last device on the circuit. It accepts either normally open (N/O) or normally closed (N/C) detec-
tion devices.
The maximum loop resistance for each zone input is 300 ohms, plus the 2 k Ohm EOL resistor.
Connecting Intrusion
Detection Devices
Figure 3 shows the typical wiring for N/C
and N/O door/window intrusion detec-
tion.

Connecting the AC Power Transformer

!
Do not plug in the power transformer at this time. The panel must be powered up using
the sequence of steps described in the "Powering up the Panel" section.
Caution
Z Z
C O
O N
AC
M E
1 2 3 4
Figure 4. Connecting a Power Transformer

Connecting the Backup Battery Pack

The panel will receive its primary power from an AC class II transformer. In the event of an AC
power failure, the panel will be powered by a battery pack containing four rechargeable NiCd
batteries.
¾
To connect the backup battery pack:
1. Remove the panel housing from the back mounting plate by lifting the tab located on the top
of the panel and pulling back.
Normally
Closed
(N/C)
Contacts
In Series
2 k Ohm
EOL Resistor
49-467
Figure 3. Wiring N/O or N/C Intrusion Detection devices
The panel must be powered by a UL approved trans-
former. Connect the power transformer to the panel
as shown in Figure 4.
Location
Battery
Pack
Battery Pack
Wire Channel
Battery Pack
Lead
Battery Connector
Wire Terminals
Figure 5. Connecting the Battery Pack
Panel Terminals
3 4 3 4
Normally
Open (N/O)
Contacts
In Parallel
Or
2 k Ohm
EOL Resistor
49-467
Installing the System