Add (2Nd Tier); Delete (2Nd Tier) - GE 60-874-95R Installation Instructions Manual

Note
When installing Crystal sen-
sors and encrypted keychain
touchpads, use the installa-
tion instructions included
with the sensor.
Note
To override the preassigned
sensor number, use the arrow
keys to skip to the desired sen-
sor number.
Note
Deleting zones/sensors does
not delete text associated with
the deleted zone/sensor num-
ber.
Installer Programming Menus
Sound
Glassguard
Smoke
Rate of Rise
DTIM
Device
Door/Window Sensor (SAW)
Motion Sensor
Keychain Touchpad (non encrypted)
Keychain Touchpad (encrypted)
Crystal Sensors
DTIM
Hardwire Sensor
Carbon Monoxide Alarm

ADD (2nd Tier)

(Default = None)
When adding devices, the panel will automatically assign the device to a sensor group based on
the type of device. Table 2 outlines the sensor group assigned to each device.
¾
To add a device:
1. Press #. The display shows
2. Trip the sensor (see Table 3). The panel beeps twice to indicate the sensor was successfully
learned into the panel.
3. Repeat step 2 until all desired zones are added.

DELETE (2nd Tier)

(Default = None)
The following procedure describes how to remove hardwire and wireless sensors from panel
memory.
¾
To delete a device:
1. To select a different zone press
displayed zone. The display shows the next sensor.
2. Repeat step 1 until all desired zones are deleted.
Table 2: Sensor Group Assigned to Device
Device
17
17
26
26
39
Table 3: Device Programming
Press button on top of sensor (cover removed).
Press and release the button on back of sensor (mounting
plate removed).
Press lock & unlock buttons until LED blinks.
See Note.
See Note.
3-2-1 sequence (page 6).
For normally closed - separate sensor from magnet.
For normally opened - close sensor then reopen.
Plug in the module and within 30 seconds, press and hold
the TEST/RESET button until you hear 6 beeps.
{01- 20} -
ZONE TRIP
to scroll through the learned zones. Press # to delete the
Sensor Group
To Program
.
(DEVICES—)
(DEVICES—)
11