26
Simon XT TableTop Control Panel
User Manual
Top-level menus
This section explains the top-level menus, with the exception of system programming, which makes up the
bulk of the menus and can be found in its own section,
Set clock
If the panel loses both AC and battery power, then upon restoring power the system time will default to
midnight and blink, indicating it has not been set correctly. Your installer can set your system time to display in
either 12-hour or 24-hour format.
Time of day format is HH:MMx
Where:
HH = 01 to 12 (12-hour format) or 00-23 (24-hour format)
MM = 00 to 59
x = a or p (12-hour format) or none (24-hour format)
To reset the clock, do the following:
1. Scroll up/down until the display shows Set clock and press Enter.
2. The display shows Enter code. Enter your master code with numeric keys and press Enter.
3. Press Enter again.
4. The display now flashes the hours. Scroll up/down to set the hours and press the Enter to accept.
5. The display now flashes the minutes. Scroll up/down to set the minutes and press the Enter to accept.
6. The display is now flashing the AM/PM. Scroll up/down to set the AM/PM and press Enter to accept.
7. The display now shows the current time, and stops flashing. Press Status twice to exit.
Light schedules
The system will automatically turn certain lights on or off according to light schedules you can define in menu
item System programming > Light control > Light schedules. See
To enable or disable scheduled lights, do the following:
1. Scroll up/down until the display reads Light schedules and press Enter.
2. The current setting will flash. Scroll up/down to toggle this option on/off and press Enter.
3. The setting will stop flashing. Press Status to exit.
A clock icon appears in the display when scheduled lights are enabled.
Note: This menu option will not appear if no light schedules are defined.
System programming
on page 29.
Light control (optional)
on page 14.