The Downloader Code cannot
be deleted from panel memory.
To change the Downloader
Code to its default setting,
enter 12345 when program-
ming the Downloader code.
Installer Programming Menus
Downloader (1st Tier)
The DOWNLOADER menu lets you set up the Allegro panel for use with ToolBox downloader
software. The DOWNLOADER menu contains the following 2nd tier menus:
NUMBER (2nd Tier)
(Default = none, Parameters = 24 digits; 0-9, *, #, pause)
Use this setting to enter the phone number of an off-site computer that can be used to program
the panel through the phone line. Phone numbers can be 1 to 24 digits long, including pauses or
* and # characters (see "Number 1 and 2 (3rd Tier)" on page 8).
The phone numbers are not accessible if a Dealer Code is programmed and the Installer Code is
used to enter installer programming mode. To access these numbers when a Dealer Code is pro-
grammed, you must enter installer programming mode using the Dealer Code.
For this feature to work, the DTIM must be connected to a phone line with a Downloader phone num-
ber, and with a Downloader code.
Call-waiting services should be disabled to prevent interrupting panel communication to the down-
loader. To program a dialing prefix that disables call-waiting, see the Pre-dial String setting page 10.
To program a Downloader Number:
Enter 1-24 digit number and then press #.
To delete a Downloader Number
Press # twice. Once to delete the number and again to accept the command.
DL CODE (2nd Tier)
(Default = 12345, Parameters = 5 digits; 0-9)
The 5-digit downloader code is used in conjunction with downloader programming. The down-
loader operator must have the panel account number, dealer code, and downloader code in
order to perform any programming.
To program a Downloader Code:
Enter 5-digit code and then press #.
Codes (1st Tier)
The CODES menu lets you define codes for the Allegro system. The CODES menu contains the
following 2nd tier menus, or codes:
INSTALL CODE (2nd Tier)
(Default = 4321, Parameters = 4 digits; 0-9)
The 4-digit installer code is used for entering program mode and changing system settings. If a
dealer code is programmed, all settings except phone numbers, pre-dial string, and downloader
number and dealer code can be changed.
To change an Installer Code:
Enter 4-digit code and then press #.