Download  Print this page

Codes (1st Tier); Manager (2nd Tier); Maintanance Code (2nd Tier); Primary (2nd Tier) - GE 60-874-95R Installation Instructions Manual

Hide thumbs

Advertisement

Note
This code will only be dis-
played in user programming if
the manager code was used to
enter user program mode.
Note
This code will only be dis-
played in user programming if
the manager code was used to
enter user program mode.
22

Codes (1st Tier)

The CODES menu lets you define security codes for the Allegro system. The CODES menu con-
tains the following 2nd tier menus, or codes:
MANAGER
MAINTENANCE
PRIMARY
USER, 2, 3, 4

MANAGER (2nd Tier)

(Default = none, Parameters = 4 digits, 0 to 9)
The manager code functions the same as the primary code within the user programming menu,
and can arm or disarm the system.
¾
To program/change Manager Code:
1. Enter the manager code. The display shows
2. Press #. The display shows
3. Press # to display the current code (if any).
4. Press #, enter the desired code and then press #.
¾
To delete Manager Code
Š Press # twice. Once to delete the code and again to accept the command.

MAINTANANCE CODE (2nd Tier)

(Default = none, Parameters = 4 digits, 0 to 9)
The maintenance code is to be used in conjunction with the apartment manager keychain
touchpad. When a maintenance person needs access to a site protected by an Allegro, he can
press disarm on the apartment manager keychain touchpad, enter the premises, then enter the
maintenance code at the panel to disarm the system.
¾
To set the Maintenance Code:
Š Press #, enter the desired code and then press #.
¾
To delete Maintenance Code
Š Press # twice. Once to delete the code and again to accept the command.

PRIMARY (2nd Tier)

(Default = 1234, Parameters = 4 digits, 0 to 9)
The primary code performs all system operations and user programming.
¾
To set the Primary Code:
1. Press # to display the current code.
2. Press #, enter the desired code and then press #.

USER 2, 3, 4 (2nd Tier)

(Default = none, Parameters = 4 digits, 0 to 9)
User Codes performs arming and disarming functions. The user codes cannot directly bypass
sensors or program the primary code. The system allows up to 3 user codes (user 2 - 4).
¾
To program/change User 2, 3, 4 Code:
1. Press # to display the current user code (if any).
2. Press #, enter the desired user code and then press #.
¾
To delete User 2, 3, 4 Code
Š Press # twice. Once to delete the code and again to accept the command.
.
CODES
.
MANAGER
(CODES—)
(CODES—)
(CODES—)
(CODES—)
User Programing Menu Items

Advertisement

   Also See for GE 60-874-95R

This manual also for:

Allegro

Comments to this Manuals

Symbols: 0
Latest comments: