Table of Contents
Advertisement
Installer Programming Menus
LOW LVL (3rd Tier)
(Default = Phone 1: on, Phone 2: off, UL installations = On)
When this setting is on, the following non-alarm conditions report to the central station:
•
AC Failure
•
Forced Arming
•
Entering or Exiting Sensor Test Mode
•
Hardwire Zone Trouble
•
RF Supervisory
•
RF Low Battery
•
Low Panel Battery
•
Phone Test
¾
To turn Low Level reports on or off under Phone 1/2:
Š Press # to turn it on or off.
OPENINGS (3rd Tier)
(Default = Off)
This setting determines whether an opening report is sent to the central station. When turned
on, the panel sends an opening report when the system is disarmed.
¾
To turn Openings reports on or off under Phone 1 or 2:
Š Press # to turn it on or off.
CLOSINGS (3rd Tier)
(Default = Off)
This setting determines whether a closing report is sent to the central station. When turned on,
the panel sends a closing report when the system is armed.
¾
To turn Closings reports on or off under Phone 1 or 2:
Š Press # to turn it on or off.
BACKUP (3rd Tier)
(Default = On)
This setting determines whether the DTIM uses phone number 2 for reporting if three initial
attempts on phone number 1 are unsuccessful.
makes up to 16 attempts (8 per phone number), alternating between the two programmed
phone numbers.
For example, if Backup is on and three failed reporting attempts occur using
1
displays
), the DTIM switches to
PHONE
FAIL
these attempts fail, (panel displays
more reporting attempts and, if necessary, switches back to
these final attempts fail, the panel will display
¾
To turn Backup on or off:
Š Press # to turn it on or off.
(PHONES—PHONE1 & PHONE 2—)
(PHONES—PHONE 1 & PHONE 2—)
(PHONES—PHONE 1 & PHONE 2—)
1 is backed up by
PHONE
2 for three more reporting attempts. If
PHONE
2
), the DTIM switches back to
PHONE
FAIL
PHONE
.
PHONE FAILURE
(PHONES—PHONE 2—)
2 . The DTIM
PHONE
1 , (panel
PHONE
1 for five
PHONE
2 for five final attempts. If
9
Hide quick links:
Advertisement
Table of Contents
