Applying Effects In Performance Mode - Roland Fantom-Xa Owner's Manual

Adding Effects

Applying Effects in Performance Mode

In Performance mode you can use three multi-effects (MFX1, MFX2, MFX3), one chorus, and one reverb. For each of the three multi-effects, the
chorus, and the reverb, you can specify whether it will operate according to the effect settings of the performance, or according to the effect
settings of the patch or rhythm set assigned to the part you specify. The three multi-effects can be used independently, or you can connect two or
three of them in series.
Specifying How the Sound Will Be Output (Routing)
Here you can make overall settings for effects, and the output destination and level of each signal.
fig.RoutingPfm
4
1 7
2
5
3
8
6
For details on these settings, refer to Making Effect Settings (p. 157).
* For the following parameters
Parameter Value
Part Select 1–16
1
Part Output MFX, A, B, 1–4,
2
Assign PAT
Part Output 1–3
3
MFX Select (MFX1–MFX3)
Part Output 0–127
4
Level
Part Chorus 0–127
5
Send Level
Part Reverb 0–127
6
Send Level
MFX Source PRF, P1–P16
7
MFX Type 0–78
MFX Structure 1–16
8
MFX Output 0–127
9
Level
MFX Chorus 0–127
10
Send Level
MFX Reverb 0–127
11
Send Level
160
17
9
14
12
15
10
16
11
13
7 9 11 14
, – , and settings can be made individually for three systems multi-effects (MFX1–MFX3).
Explanation
Part for which you want to make settings
Specifies for each part how the direct sound will be output.
MFX: Output in stereo through multi-effects. You can also apply chorus or reverb to the sound
that passes through multi-effects.
A, B: OUTPUT A (MIX) jack or OUTPUT B jack in stereo without passing through multi-effects
1–4: INDIVIDUAL 1–4 jacks in mono without passing through multi-effects
PAT: Determined by the settings of the patch or rhythm set assigned to the part.
* If the Mix/Parallel parameter is set to "MIX," all sounds are output from the OUTPUT A (MIX) jacks in
stereo (p. 194).
Specifies which multi-effects will be used.
Level of the signal sent to the output destination specified by Part Output Assign (
Level of the signal sent to chorus for each part
Level of the signal sent to reverb for each part.
Multi-effects parameter settings used by the performance
PRF: Performance settings
P1–P16: Settings of the patch/rhythm set assigned to one of the parts (Select the part number.)
Selects from among the 78 available multi-effects.
For details on multi-effects parameters, refer to Multi-Effects Parameters (p. 164).
Specifies how MFX1–3 will be connected.
Volume of the sound passed through the multi-effects
Amount of chorus for the sound passed through multi-effects
Amount of reverb for the sound passed through multi-effects
2
)