Turning On/Off The Power; Adjusting The Display Contrast (Lcd Contrast) - Roland Fantom-Xa Owner's Manual

High - quality workstation synthesizer
Hide thumbs Also See for Fantom-Xa:
Table of Contents

Advertisement

Getting Ready

Turning On/Off the Power

941
* Once the connections have been completed (p. 15), turn on power to
your various devices in the order specified. By turning on devices in
the wrong order, you risk causing malfunction and/or damage to
speakers and other devices.
1.
Before turning on the Fantom-Xa's power, consider these
two questions:
• Are all devices connected properly?
• Have the volume controls of the Fantom-Xa and all connected
audio devices been turned to their lowest settings?
2.
Turn on the POWER ON switch located on the rear panel of
the Fantom-Xa.
fig.PowerOn
942
* This unit is equipped with a protection circuit. A brief interval (a few
seconds) after power up is required before the unit will operate
normally.
* To ensure proper operation of the pitch bend lever, make sure not to
touch the lever when turning the Fantom-Xa's power on.
Do not touch!
3.
Turn on the power for any connected audio devices.
4.
While playing the keyboard, gradually raise the volume of
the Fantom-Xa and connected devices.
fig.Volume
16
Turning Off the Power
1.
Before turning off the power, consider these two questions:
• Have the volume controls of the Fantom-Xa and all connected
audio devices been turned to their lowest settings?
• Have you saved your Fantom-Xa sounds or other data you've
created?
2.
Turn off the power for all connected audio devices.
3.
Turn off the POWER ON switch of the Fantom-Xa.
Adjusting the Display
Contrast (LCD Contrast)
The characters in the display may be difficult to view immediately
after turning on the Fantom-Xa's power or after extended use. Your
viewing angle or the current lighting conditions can also affect the
appearance of the display. In such situations, adjust the contrast of
the display.
1.
Hold down [SHIFT] and press [PAGE] to open the LCD
Contrast window.
2.
Turn the VALUE dial to adjust the contrast.
* If you want to keep the contrast of the display, save the setting in
internal system memory (p. 192).

Advertisement

Table of Contents
loading

Table of Contents