Applying Effects In Performance Mode; Specifying How The Sound Will Be Output (Routing); Signal Flow Diagram And Parameters; Part Output Assign - Roland Fantom-X6 Owner's Manual

Adding Effects
Applying Effects in
Performance Mode
In Performance mode you can use three multi-effects (MFX1, MFX2,
MFX3), one chorus, and one reverb. For each of the three multi-
effects, the chorus, and the reverb, you can specify whether it will
operate according to the effect settings of the performance, or
according to the effect settings of the patch or rhythm set assigned to
the part you specify. The three multi-effects can be used
independently, or you can connect two or three of them in series.
Specifying How the Sound Will Be
Output (Routing)
Here you can make overall settings for effects, and the output
destination and level of each signal.
fig.22-006.eps_50
For details on these settings, refer to "Making Effect Settings"
(p. 206).
Signal Flow Diagram and
Parameters
fig.22-007
1
2 3
7
7
4
7
12
5
16
6
Part Select
1
Select the part for which you want to make settings.
Value: 1–16
210
21
20
11
8
9
10
8 11
9
10
11
8
9
10
13
14
15
17 18

Part Output Assign

2
Specifies for each part how the direct sound will be output.
Value
Output in stereo through multi-effects. You can also
MFX:
apply chorus or reverb to the sound that passes
through multi-effects.
A, B: Output to the OUTPUT A (MIX) jack or OUTPUT B
jack in stereo without passing through multi-effects.
1–4: Output to the INDIVIDUAL 1–4 jacks in mono
without passing through multi-effects.
PAT: The part's output destination is determined by the
settings of the patch or rhythm set assigned to the
part.
If you've made settings so that sounds are separately routed to
the INDIVIDUAL 1 jack and INDIVIDUAL 2 jack, but no plug
is actually inserted in the INDIVIDUAL 2 jack, the sounds
routed to INDIVIDUAL 1 and INDIVIDUAL 2 will be mixed
and output from the INDIVIDUAL 1 jack.
If the Mix/Parallel parameter is set to "MIX," all sounds are
output from the OUTPUT A (MIX) jacks in stereo (p. 230).
If you've set Tone Out Assign to "MFX," set the MFX Output
11
Assign parameter ( ) to specify the output destination of the
sound that has passed through the multi-effects.
• Chorus and reverb are output in mono at all times.
• The output destination of the signal after passing through the
chorus is set with the Chorus Output Select (
Chorus Output Assign (
• The output destination of the signal after passing through the
reverb is set with the reverb Output Assign (
Part Output MFX Select (Part Output Multi-
3
Effects Select)
Of the three systems of multi-effects that can be used
simultaneously, specify which multi-effects will be used.
Value: 1–3(MFX-1–MFX-3)
Part Output Level
4
Set the level of the signal that is sent to the output destination
specified by Part Output Assign (
Value: 0–127
Part Chorus Send Level
5
Sets the level of the signal sent to chorus for each part.
Value: 0–127
13
) and the
15
).
18
).
2
).