Roland Fantom-Xa Owner's Manual page 142

Editing Songs
Shifting Performance Data
Forward and Back (Shift Clock)
This function shifts the timing of sequencer data backward or
forward in time within a specified area in steps of 1 tick. Slight shifts
of timing can speed up or drag performance.
* When this function is executed, data that would be moved to a point
before the beginning of the song will automatically shift to the
beginning of the song. If data would be moved to a point past the end
of the song, additional new measures will be created automatically as
needed. The time signature of the newly created measures will be the
same as that of the measure immediately preceding.
For details on the settings, refer to Basic Operation for Track
Editing (p. 133).
fig.ShiftClock
Parameter Value
Track/Pattern TRK ALL,
TRK 1–16,
TEMPO,
PTN001–100
ALL: Phrase tracks 1–16, the beat track, and
the tempo track
TRK 1–16: Specified phrase track
TEMPO: Tempo track
PTN001–100: Specified pattern
Ch/Part ALL, Ch 1–16
ALL: Shifts ticks of all sequencer data.
Ch 1–16: Shifts the sequencer data tick of just
one specific MIDI channel.
* If you set "Track" to "TEMPO," or if "Status" is
set to "System Exclusive," "Tune Request" or
"Pattern Call," this parameter will not be avail-
able.
Measure 0001–
For 1–ALL
Bias -4800–4800
Status ALL, Note,
Poly Aftertouch,
Control Change,
Program Change,
Channel After-
touch, Pitch Bend,
System Exclusive,
Tune Request,
Pattern Call
142
Explanation
Track(s) or pattern whose
sequencer data will be
moved in units of one tick
MIDI channel of the data
to be shifted in time
Range of measures in
which the sequencer data
will be moved in units of
one tick.
If you set "For" to
"ALL," all measures
will be specified.
Amount (number of
ticks) by which the se-
quencer data will be
moved
Type of data to be shifted
in time
* If "Track" is set to
"TEMPO," this parame-
ter will not be available.
Parameter Value
When "Status" is "Note" or "Poly Aftertouch"
Range Min 0 (C -)–127 (G9)
Range Max
When "Status" is "Control Change"
Range Min 0–127
Range Max
When "Status" is "Program Change"
Range Min 1–128
Range Max
Explanation
Range of note numbers to
be shifted
You can also specify
the key range by press-
ing keys on the key-
board.
Range of controller num-
bers to be shifted
Range of program num-
bers to be shifted