Roland Fantom-Xa Owner's Manual page 61

Parameter Group [F3 (WAVE MIX)]
[F1 (LV/PAN)]
Parameter Value
Wave Level 0–127
Wave Pan L64–0–63R
Wave Rnd Pan Sw OFF, ON
Wave Alter Pan Sw OFF, ON,
REVS
[F2 (TUNE)]
Parameter Value
Wave Coarse Tune -48– +48
Wave Fine Tune -50– +50
[F3 (VEL RNG)]
You can use the force with which keys are played to control the way each waveform is played.
fig.TMT-V.e
The waveform sounded
Level
when you play softly
Velo Fade Lower
Velo Range Lower
Parameter Value
Velocity Control OFF, ON,
RAN
Velo Fade Lower 0–127
Velo Range Lower 1–UPPER
Velo Range Upper LOWER–127
Velo Fade Upper 0–127
Description
Volume of the waveform
Left/right position of the waveform
Use this setting to cause the waveform's panning to change randomly each time a key is pressed (ON)
or not (OFF).
* The range of the panning change is set by the Random Pan Depth parameter (p. 64).
This setting causes panning of the waveform to be alternated between left and right each time a key
is pressed.
Set this to "ON" to pan the wave according to the Alternate Pan Depth parameter (p. 64) settings,
or to "REVS" when you want the panning reversed.
Explanation
Pitch of the waveform's sound (in semitones, +/-4 octaves)
Pitch of the waveform's sound (in 1-cent steps; one cent is 1/100th of a semitone)
The waveform sounded
when you play strongly
Velocity
Velo Fade Upper
Velo Range Upper
Explanation
Determines whether a different waveform is played (ON) or not (OFF) depending on the force with
which the key is played (velocity).
RAN: The rhythm tone's constituent waveforms will sound randomly, regardless of any Velocity
messages.
Determines what will happen to the waveform's level when the rhythm tone is played at a velocity
lower than Velo Range Lower.
If you don't want the waveform to sound at all, set this parameter to "0."
Specifies the lowest velocity at which the waveform will sound.
Specifies the highest velocity at which the waveform will sound.
Determines what will happen to the waveform's level when the rhythm tone is played at a velocity
greater than Velo Range Upper.
If you don't want the waveform to sound at all, set this parameter to "0."
Creating a Rhythm Set
61