Applying Effects In Performance Mode; Signal Flow And Parameters (Effect Routing) - Roland Juno-Stage User Manual

Chapter 5. Applying Effects to the Sound

Applying Effects in Performance Mode

In Performance mode you can use three multi-effects (MFX1, MFX2, MFX3), one chorus, and one reverb. The three multi-effects, chorus, and reverb
can each use the effect settings of the performance, or the effect settings of the patch or rhythm set assigned to the specified part.
In addition, the three multi-effects can not only be used individually but also as a combination of multi-effects.

Signal Flow and Parameters (EFFECT ROUTING)

Here you can make overall settings for effects, such as the output destination and level of the various signals.
fig.RoutingPfm_70
4 7
1
5
2
8
3 6
For details on how to make settings, refer to "Making Effect Settings" (p. 79).
* The parameters listed below in
Parameter
Part Select
1
Part Output Assign
2
Part Output MFX
3
Select
Part Output Level
4
Part Chorus Send
5
Level
Part Reverb Send
6
Level
MFX Source
7
MFX Type
MFX Structure
8
MFX Output Level
9
MFX Chorus Send
10
Level
MFX Reverb Send
11
Level
82
9
12
10
14
13
11 15
7 9 11
, – can be edited for each of the three multi-effects (MFX1–MFX3).
Range Explanation
UPPER
(PART 1),
LOWER The part for which to make settings
(PART 2),
PART 3–16
Specifies how the unprocessed sound of each part will be output
MFX: Output in stereo via the multi-effect. Chorus and reverb can also be applied after the multi-
MFX,
effect.
L+R,
L+R: Output in stereo from the OUTPUT jacks without passing through the multi-effect
L,
R,
L: Output in mono from the OUTPUT L jack without passing through the multi-effect
PAT
R: Output in mono from the OUTPUT R jack without passing through the multi-effect
PAT: Output according to the settings of the patch or rhythm set that's assigned to the part
1–3 Multi-effect used by the part (choose one of MFX 1–3)
0–127 Level of signal sent to the destination specified by Part Output Assign
0–127 Level of signal sent from each part to the chorus
0–127 Level of signal sent from each part to the reverb
PRF,
Multi-effect parameter settings used by the performance
UP (P1),
PRF: Use the multi-effect settings of the performance
LO (P2),
UP (P1)–P16: Use the multi-effect settings of the patch or rhythm set assigned to the specified part
P3–P16
Type of multi-effect to use (choose one of 79 types)
0–79
For details on each multi-effect, refer to "Multi-Effects Parameters (MFX1–3, MFX)" (p. 163).
1–16 How MFX 1–3 will be combined (p. 86)
0–127 Volume of the sound that has been processed by the multi-effect
0–127 Amount of chorus applied to the sound that has been processed by the multi-effect
0–127 Amount of reverb applied to the sound that has been processed by the multi-effect