Moving The Cursor; Changing A Value - Roland Fantom-Xa Owner's Manual

Moving the Cursor

A single screen or window displays multiple parameters or items for
selection. To edit the setting of a parameter, move the cursor to the
value of that parameter. To select an item, move the cursor to that
item. When selected with the cursor, a parameter value or other
selection is highlighted.
fig.CursorScreen
Move the cursor with the
fig.CURSOR
: moves the cursor up.
: moves the cursor down.
: moves the cursor to the left.
: moves the cursor to the right.
• If you hold down one cursor button while you also press the
cursor button for the opposite direction, the cursor will move
more rapidly in the direction of the first-pressed cursor button.
• When the cursor is displayed, pressing [ENTER] will sometimes
display a list of the available choices for that parameter. This is
convenient when you want to see what your choices are.

Changing a Value

To change the value, use the VALUE dial or the [INC] [DEC]
buttons.
fig.VALUE
In each screen of the Fantom-Xa, you can use the cursor buttons
to move the area displayed as highlighted, and modify its value.
* Each parameter has its own range of possible values, so you cannot set
any value smaller than the minimum value or greater than the
maximum value.
Cursor
, , and (cursor buttons).
Basic Operation of the Fantom-Xa
VALUE Dial
Turning the VALUE dial clockwise increases the value,
counterclockwise decreases the value.
• Holding down [SHIFT] as you move the VALUE dial increases
value increments so you can make large value changes faster.
[INC] and [DEC]
Pressing [INC] increases the value, and [DEC] decreases it.
• Keep the button pressed for continuous adjustment.
• For faster value increases, keep [INC] pressed down and press
[DEC]. For decreasing value faster, keep [DEC] pressed down
and press [INC].
• If you press [INC] or [DEC] while holding down [SHIFT], the
value increments will get bigger.
When the cursor is located at a parameter value, press [ENTER]
to display a window where you can set the value. Use
to select a value, and then press [ENTER] to finalize the setting.
Using the pads
In some cases when the cursor is located at an input location, you
can press [ENTER] to see a list of parameter values. For some of
these lists, you can use the pads to input or specify the value.
1.
Press [TRIGGER] and [CATEGORY] simultaneously so both
buttons are lit.
You can use the pads to input or specify the value.
When inputting a numerical value
PAD [0]–[9]: Input numerals 0–9
[SHIFT]: Cancels the numeral you input
fig.PadNumber
When inputting directly
Pressing a pad will directly input the corresponding value.
From the top, the items in the list correspond to pads [0]–[9].
fig.PadDirect
27