Roland Fantom-Xa Owner's Manual page 159

Parameter Value
MFX Reverb 0–127
9
Send Level
Chorus Source KBD, PAD
10
Chorus Type 0–3
Reverb Source KBD, PAD
11
Reverb Type 0–5
MFX Output A, B
12
Assign
Chorus Out- MAIN, REV,
13
put Select M+R
Chorus Level 0–127
Chorus Out- A, B
put Assign
Reverb Level 0–127
14
Reverb Output A, B
Assign
Mastering Ef- 0–5
15
fect Type
Explanation
Amount of reverb for the sound passed through multi-effects
Chorus parameter settings
KBD: Settings of the patch or rhythm set assigned to the Keyboard part
PAD: Settings of the patch or rhythm set assigned to the Pad part
Selects either chorus or delay.
0 (OFF): Neither chorus or delay is used.
1 (CHORUS): Chorus is used.
2 (DELAY): Delay is used.
3 (GM2 CHO): General MIDI 2 chorus
Reverb parameter settings
KBD: Settings of the patch or rhythm set assigned to the Keyboard part
PAD: Settings of the patch or rhythm set assigned to the Pad part
Type of reverb
0 (OFF): Reverb is not used.
1 (REVERB): Normal reverb
2 (SRV ROOM): Simulates typical room acoustic reflections.
3 (SRV HALL): Simulates typical concert hall acoustic reflections.
4 (SRV PLATE): Simulates a plate reverb, a popular type of artificial reverb unit that derives its
sound from the vibration of a metallic plate.
5 (GM2 REV): General MIDI 2 reverb
Output destination of the sound passed through the multi-effects
A: OUTPUT A (MIX) jacks in stereo
B: OUTPUT B jacks in stereo
* If the Mix/Parallel parameter is set to "MIX," all sounds are output from the OUTPUT A (MIX) jacks in
stereo (p. 194).
Specifies how the sound routed through chorus will be output.
MAIN: Output to the OUTPUT jacks in stereo.
REV: Output to reverb in mono.
M+R: Output to the OUTPUT jacks in stereo, and to reverb in mono.
Volume of the sound passed through chorus
Selects the pair of OUTPUT jacks to which the chorus sound is routed when Chorus Output Select is
set to "MAIN" or "M+R."
A: Output to the OUTPUT A (MIX) jacks in stereo.
B: Output to the OUTPUT B jacks in stereo.
* When Chorus Output Select is set to "REV," this setting will have no effect.
Volume of the sound passed through reverb
Specifies how the sound routed through reverb will be output.
A: Output to the OUTPUT A (MIX) jacks in stereo.
B: Output to the OUTPUT B jacks in stereo.
* If the Mix/Parallel parameter is set to "MIX," all sounds are output from the OUTPUT A (MIX) jacks in
stereo (p. 194).
Mastering effect settings
Adding Effects
159