Epson TM-H6000V Technical Reference Manual page 63

NV graphics memory capacity
Select one of the following.
None (0KB)/ 64KB/ 128KB/ 192KB/ 256KB/ 320KB/ 384KB (default setting)
Roll paper width
 80mm (default setting)
 58mm
 Be sure to install the roll paper guide (model: PG-58II) when you select the 58 mm paper width.
(See
 Because some parts of the print head and the autocutter contact the platen and they may
become worn out in 58 mm printing, once you change the paper width from 80 mm to 58 mm,
you cannot change it back to 80 mm.
Receipt print density
Selectable from 70% to 130% (5% increment)
Default setting: Depends on the DIP switch settings
The specified original paper types and recommended print densities are as indicated below.
Depending on the paper type, it is recommended to set the print density as shown in the table below for the best
print quality.
Original Paper type
AF50KS-E
P220AGB-1
TF50KS-EY
P35524
P160R, KT55FA
TF60KS-EY, PD190R, KT48FA, F5041(55), F5041(48)
P30521, P30523, P31523
 When the print density level is increased, print speed may be reduced. When printing at a
density of 115% or more and below a room temperature of 15°C, the speed drops to less than
200 mm/sec.
 When setting the print speed to level 14, use customized values to set the print density.
"Changing the Paper Width" on page 54.)
Density
4 (85%)
5 (90%)
5 (90%)
6 (95%)
7 (100%)
7 (100%)
8 (100%)
Chapter 3 Advanced Usage
Print speed
13 (300 mm/sec)
13 (300 mm/sec)
14 (350 mm/sec)
13 (300 mm/sec)
14 (350 mm/sec)
13 (300 mm/sec)
13 (300 mm/sec)
63
3