Advanced Usage; Setting The Dip Switches; Setting Procedure - Epson TM-H6000V Technical Reference Manual

Advanced Usage

Setting the DIP Switches

On this printer, you can make various settings with DIP switches.
The DIP switches are already set for the current interfaces. Change the setting if necessary.
Functions of the DIP switches differ depending on the interface.

Setting Procedure

Follow the steps below to change the DIP switch settings.
CAUTION
1
Make sure the printer is turned off.
2
Unscrew the screw to remove the DIP switch cover from the base of the printer.
3
Set the DIP switches, using the tip of a tool, such as a small screwdriver.
4
Replace the DIP switch cover, and screw it in place.
 Before you remove the DIP switch cover, turn off the printer and disconnect all cables.
Otherwise, a short-circuit may cause the printer to malfunction.
 If you open the DIP switch cover, be sure to close the cover and tighten the screw after
adjusting the DIP switch.
Using this product with the cover open may cause fire or electric shock.
 DIP switch settings are enabled only when the power is turned on or the printer is reset via the
interface. If the settings are changed after that, the functions will not change.
 Do not change switches that are fixed to ON or OFF. Otherwise, the printer may not operate
normally.
Chapter 3 Advanced Usage
DSW1
(DIP switch 1)
DSW2
(DIP switch 2)
3
55