Epson TM-H6000V Technical Reference Manual page 133

 Choose slip paper carefully when using slip paper with glued area, since printing, paper feeding,
and insertion are affected by gluing conditions (e.g. quality, method, and length of glue) and glue
location.
Be especially careful when slip paper is wide and has the glue on the left edge, since drifting may
occur.
OK to use
Paper inserting direction
 Use thinner paper (N30 or equivalent) between the top and bottom sheets of multi-ply paper. If
thick paper is used, the copy capability is lowered.
 Do not use paper that has holes, or is translucent at the BOF sensor position.
 Do not use paper that has holes or dark positions with low reflection (less than 40% reflection) on
the front at the TOF sensor position.
Paper inserting
direction
Do not use paper that has holes or dark positions with low reflection (less than 40% reflection) on
the back at the validation sensor (only for the validation models).
Paper inserting
direction
Use carefully Use carefully
Glued area
40
20
10
[units: mm (All the numeric values are typical.)]
20
[units: mm (All the numeric values are typical.)]
Appendix
Use carefully
Glued area
Area where holes are prohibited
and reflection rate on the front
should be 40% or more.
Area where holes are prohib-
ited and reflection rate on the
front should be 40% or more.
133