Specifications; Warranted Characteristics - Tektronix P5200 Instruction Manual

Specifications
The specifications in the following tables apply to a P5200 High Voltage
Differential Probe installed on a Tektronix TDS460A oscilloscope.
When the probe is used with another oscilloscope, the oscilloscope must
have an input impedance 1 M Ω an input capacitance range of between
15 and 20 pF, and a bandwidth not less than 100 MHz.
The probe must have a warm-up period of at least 20 minutes and be in
an environment that does not exceed the limits. (See Table 2.)
Specifications for the P5200 probe fall into three categories: warranty,
typical, and nominal characteristics.
WARNING.
maximum frequency and voltage levels and should be conducted only by
qualified Service Personnel. See the Service section for more details.

Warranted Characteristics

The warranted characteristics describe guaranteed performance within
tolerance limits or certain type-tested requirements. Warranted
characteristics that have check procedures in the Performance
Verification section are marked with the
Table 2: Warranted Electrical Characteristics
Characteristics
Rise Time
DC Common Mode
Rejection Ratio
(20-30°C, <70% RH)
Bandwidth
Maximum Operating Input
Voltage
P5200 Instruction Manual
Special fixtures are required to examine specifications at the
Description
<14 ns in 1/50 range setting
>3000:1 at 500 VDC
DC to 25 MHz (-3dB) in 1/50 range setting
1/500 differential: ±1.3 kV (DC + peak AC)
1/500 common mode: ±1 kV
1/50 differential: ±130 V (DC + peak AC)
1/50 common mode: ±1 kV
symbol.
CAT II
RMS
CAT II
RMS
15