Jumper And Switch Settings - Daikin Super Multi NX FFQ25B8V1B Service Manual

Field Settings

5.1.3 Jumper and Switch Settings

<Floor Standing Type>
Switch (on indoor unit
<Floor / Ceiling Suspended Dual Type>
Switch (on indoor unit
For the location of the jumper and the switch, refer to the following pages.
450
Jumper (on indoor
unit PCB)
JB Fan speed setting
when compressor
stops for thermostat
OFF. (effective only
at cooling operation)
JC Power failure
recovery function
PCB)
SW2-4 Upward airflow limit
setting
PCB)
SW2 Installation style
changeover
Wall mounted type: page 51, 54, 57
Floor Standing Type: page 60
Floor / Ceiling Suspended Dual Type: page 62
Duct connected type: page 64
Function When connected
(factory set)
Fan speed setting ;
Remote controller
setting
Auto-restart
Function OFF (factory set)
Exposed or half
embedded
installation
Function FLOOR (factory
set)
When installed as
the floor mounted
type
SiBE121021_C
When cut
Fan speed setting; "0" (The fan
stops.)
The unit does not resume
operation after recovering from a
power failure. Timer settings are
cleared.
ON
Set the switch to ON position
when you install the indoor unit
embedded in the wall to avoid
condensation.
CEILING
When installed as the ceiling
suspended type
Trial Operation and Field Settings