Daikin Super Multi NX FFQ25B8V1B Service Manual page 174

RA Indoor Unit
Indoor Unit
1. Titanium Apatite Photocatalytic
Air-Purifying Filter:
• These filters are attached to the inside of
the air filters.
2. Air outlet
3. Display
4. Front panel
5. Vertical blades (louvers)
• The louvers are inside of the air outlet.
6. Air inlet
7. Air filter
8. Horizontal blade (flap)
9. Operation lamp (green)
10. TIMER lamp (yellow)
11. Indoor Unit ON/OFF switch:
• Push this switch once to start operation.
Push once again to stop it.
162
• The operation mode refers to the following
table.
Model Mode
COOLING
COOL
ONLY
HEAT
AUTO
PUMP
• This switch is useful when the remote
controller is missing.
12. Signal receiver:
• It receives signals from the remote
controller.
• When the unit receives a signal, you will
hear a short beep.
• Operation start ........ beep-beep
• Settings changed ..... beep
• Operation stop.......... beeeeep
13. Air outlet selection switch
14. Room temperature sensor:
• It senses the air temperature around the unit.
SiBE121021_C
Temperature Airflow
setting rate
22˚C AUTO
25˚C AUTO
Operation Manual