Jumper And Switch Settings - Daikin 2MKS40G2V1B Service Manual

SiBE12-816_D

4.1.3 Jumper and Switch Settings

<Floor Standing Type>
<Floor / Ceiling Suspended Dual Type>
For the location of the jumper and the switch, refer to the following pages.
Trial Operation and Field Settings
Jumper
(on indoor unit PCB)
JB Fan speed setting
when compressor
stops for thermostat
OFF. (effective only
at cooling operation)
JC Power failure
recovery function
Switch
(on indoor unit PCB)
SW2-4 Upward airflow limit
setting
Switch
(on indoor unit PCB)
SW2 Installation style
changeover
Wall mounted type: page 33, 35, 38
Floor Standing Type: page 41
Floor / Ceiling Suspended Dual Type: page 43
Duct connected type: page 45
Function When connected
(factory set)
Fan speed setting ;
Remote controller
setting
Auto-restart
Function OFF
(factory set)
Exposed or half
embedded
installation
Function FLOOR
(factory set)
When installed as
the floor mounted
type
Field Settings
When cut
Fan speed setting; "0" (The fan
stops.)
The unit does not resume
operation after recovering from a
power failure. Timer settings are
cleared.
ON
Set the switch to ON position
when you install the indoor unit
embedded in the wall to avoid
condensation.
CEILING
When installed as the ceiling
suspended type
306