Jumper And Switch Settings - Daikin Floor Standing Type F-Series Service Manual

Field Settings
Caution 1. If the outdoor unit is installed where the outdoor heat exchanger of the unit is exposed to
2. Intermittent noises may be produced by the indoor unit due to the outdoor fan turning on and
3. Do not place humidifiers or other items which might raise the humidity in rooms where facility
4. Cutting jumper sets the indoor fan tap to the highest position. (25/35 class)
5. Use the indoor unit at the highest level of airflow rate. (50 class)
2.5

Jumper and Switch Settings

JB
(on indoor unit PCB)
JC
(on indoor unit PCB)
J5
(on outdoor unit PCB
of 25/35 class)
SW4-C
(on outdoor unit PCB
of 50 class)
<Floor Standing Type>
SW2-4
For the location of the jumper and the switch, refer to the following pages.
Indoor unit; page 21
Outdoor unit; page 23, 25, 27, 29
261
RKS50F2V1B, RKS50G2V1B
S102
S2
LED-A
SW4
SW1
direct wind, provide a windbreak wall.
off when using facility settings.
settings are being used.
A humidifier might cause dew jumping from the indoor unit outlet vent.
Jumper
Fan speed setting
when compressor
stops for thermostat
OFF.
(effective only at
cooling operation)
Power failure
recovery function
Improvement of
defrost performance
Switch
Improvement of
defrost performance
Switch
Upward airflow limit
(on indoor unit PCB) setting
Turn on the
switch SW4-B.
Function When connected
(factory set)
Fan speed setting ;
Remote controller
setting
Auto-restart
Standard control
Function OFF (factory set)
Standard control
Function OFF
(factory set)
Exposed or half
embedded
installation
SiBE06-708_A
(R12186)
When cut
Fan rpm is set to "0"
<Fan stop>
The unit does not resume
operation after recovering from
a power failure. Timer ON/OFF
settings are cleared.
Reinforced control
(ex. The frequency increases,
the duration time of defrost
lengthens.)
ON
Reinforced control (ex. The
frequency increases, the
duration time of defrost
lengthens.)
ON
Set the switch to ON position
when you install the indoor unit
embedded in the wall.
Trial Operation and Field Settings