Table of Contents
Advertisement
NUMBER
4
5
4.2 View Input-level Information
When the MPH2 is first turned on, the input level information of the main screen is shown on the display.
NOTE: If no key has been pressed after five minutes, the on-board LCD returns to the main screen.
NOTE: During a firmware upgrade: The Line LEDs flash red and green, and the rack PDU continues to
receive and distribute power without interruption.
Figure 4.2 Input-level information (main screen)
NUMBER
DESCRIPTION
1
Input-level metered information icon
2
Bar graph of input current
3
Link icon
4
Input voltage
5
Voltage phase
6
Information icon
4.2.1 Communication Link with RPC2
When power is cycled to the MPH2™ Rack PDU, it takes a few minutes to establish communication and
load the configuration information from the RPC2 module, such as receptacle labels and IP and MAC
addresses.
When configuration changes (such as turning-on/off a receptacle) require that the display update, the
configuration wheel appears and spins.
Vertiv | Vertiv™ MPH2 Rack PDU Installer/User Guide
DESCRIPTION
Select key
Left-arrow key
NUMBER
DESCRIPTION
7
Receptacle icon
8
Sensor icon
9
Alarm icon
10
% Amperes used until alarm threshold.
11
Unit identification (always shows unit 1)
26
Advertisement
Table of Contents
