Temperature/Humidity Sensor Installation - Vertiv MPH2 Installer/User Manual

Rack pdu

Hide thumbs Also See for MPH2:

Table of Contents

3.5.2 Temperature/Humidity Sensor Installation

Optional Liebert

rack. Liebert SN sensors are designed for installation in Vertiv™ racks without tools, but each may be

placed in any area to monitor temperature and humidity levels. Each connects to the RPC2

communications module, which makes readings available to other monitoring systems.

To install a sensor in a rack:

Insert the sensor bracket base into one end of the sensor support.

2. Snap the sensor into the other end of the sensor support.

3. Choose where in the rack to install the sensor assembly.

NOTE: Vertiv™ recommends placing the sensor in the area of the rack that is likely to be warmest. That

location helps determine extreme conditions that can cause equipment damage.

4. Hold the sensor bracket on a T-slot on the Vertiv™ rack frame where the sensor will be placed.

5. Insert the included quarter-turn fastener through the rectangular hole in the sensor bracket

base and into the T-slot.

6. Turn the fastener clockwise 90 degrees, completing a quarter of a turn.

7. Route the sensor cable to the RPC2 communications module and insert it into the card's

external sensor port.

NOTE: For more information, see the RPC2 user manual, SL-20841, available at

http://www.VertivCo.com

Vertiv | Vertiv™ MPH2 Rack PDU Installer/User Guide

SN temperature/humidity sensors are available to assist in monitoring conditions in the

Table of Contents