Slope Warning Device; Travel Speed Limitation; Electronic Variable Speed Drive - Haulotte optimum 8 Operator's Manual

OPTIMUM 8 - OPTIMUM 1931 E
C
- Pre-operation inspection
4.5 - S
LOPE WARNING DEVICE
From each control box, a buzzer alerts the operator that the machine is not folded/stowed and
is positioned on a slope exceeding the slope allowed.
N.B.-:-T
When the unfolded machine is on a slope greater than the rated slope, out of the stowed
position, DRIVE and LIFT functions are disabled(For CE, AS and CSA only).
All speeds are reduced
In this case, fully lower the platform and reposition the machine on level ground before raising
the platform again.
N.B.-:-D
IN ORDER TO CARRY OUT THIS OPERATION
Step
1 Pull the E-stop push-buttons on the platform and ground control boxes (46, 15).
2 Switch on the machine from the ground control box (92).
3 Lower the platform completely.
3 Locate the tilt sensor next to the ground control box.
4
Manually tilt and maintain the tilt sensor towards the front for a few seconds (
5 The audible beep sounds.
For machines fitted with : The slope sensor prevents lifting and driving movements (For CE, AS and CSA
6
only).
4.6 - T
RAVEL SPEED LIMITATION
Drive speed is proportional to control, without restriction, until the maximum speed is reached
(machine in fully stowed position).
The only speed allowed when not in stowed position is microspeed (This speed is a default
speed programed into the machine).
4.7 - E
LECTRONIC VARIABLE SPEED DRIVE
The machines are equipped with 2 electronic variable speed regulators configured for each
function and manages the required power needed for each motor.
Do not interchange the speed controllers/regulators between machines even if they are the same model.
4000415480
HE SLOPE SENSOR IS ONLY ACTIVE WHEN THE PLATFORM IS NOT IN THE STOWED POSITION
EPENDING ON YOUR MACHINE CONFIGURATION
To check the tilt sensor at ground control box
E 01.18
,
OUTSIDE ASSISTANCE MAY BE NECESSARY
.
Action
Section B 3.1 - Layout) :
USA / GB 63
A
B
.
C
D
E
F
G
H
I