Operation From The Platform Control Box - Haulotte optimum 8 Operator's Manual

OPTIMUM 8 - OPTIMUM 1931 E
D
- Operation instructions
1.3 - O
PERATION FROM THE PLATFORM CONTROL BOX
• The platform control box can only be used if :
• The E-stop buttons on both ground and platform control boxes are not pressed in (Energized).
• Machine switched on at ground control box.
• Platform control box selected from ground control box.
• A faulty joystick is not taken into account to control a movement. If this fault disappears, the
movement is authorised again.
• An E-Stop button is present at each control box. When pushed in, it stops all functions
movements and will shut off the engine (if equipped).
• An "Enable switch" ( 123 ) or Foot pedal switch in the basket ( 245 ) is present and should
be activated to authorize one or more function movements. If the enable switch is kept active
for more than 8 seconds without selecting a function movement, then movement is
disallowed. The enable switch must be released (reset) before movement can occur.
• The release of "Enable switch" ( 123 ) or Foot pedal switch in the basket ( 245 ) while
performing a movement stops all the movements. The stop of movements is progressive. If
the "Enable switch" is pressed again quickly within 0,5 s the movement restarts. If the
"Enable switch" is not pressed again quickly enough within + 0,5 s the movement will not
restart. It could restart only when the selected function switch/joystick is released to neutral
position.
• All switches and joystick operating a movement, return automatically to neutral when
released.
• At power up, a switch in it's neutral position will be taken into account to authorize movement.
• The status of the switches is tested automatically when the machine is switched on, and
checked at every starting. A switch or joystick will be active only after it has been detected
in neutral position.
A buzzer beeps in the following conditions :
• Overload (if fitted).
• Machine out of stowed position and on a slope greater than allowable slope.
• Indicators - All the indicators are tested
• When the machine is switched on.
4000415480 E 01.18 USA / GB 69
A
B
C
D
E
F
G
H
I