Slope Warning Device; Travel Speed Limitation; Electronic Variable Speed Drive - Haulotte STAR 10 Operator's Manual

STAR 10 - STAR 26J
C
- Pre-operation inspection
4.5 - S
LOPE WARNING DEVICE
From each control box, a buzzer alerts the operator that the machine is not folded/stowed and
is positioned on a slope exceeding the slope allowed.
N.B.-:-T
When machine is on a slope greater than the rated slope, with extending structure out of the
stowed position :
• The DRIVE and LIFTING (RAISING) commands are deactivated.
The lowering speeds are reduced.
In this case, fully lower the platform and reposition the machine on level ground before raising
the platform again.
To check the tilt sensor at ground level, perform the following steps :
Step
Put the machine in stowed position on a slope with an angle greater than the permitted inclination (Refer
1
to
2 Check that the tilt indicator is on ( 27).
4.6 - T
RAVEL SPEED LIMITATION
All driving speeds are allowed when the mast is retracted, whatever the jib position.
The only speed allowed when not in stowed position is microspeed (This speed is a default
speed programed into the machine).
Risk of overturning
Driving at high speed with jib above horizontal position increases the risk of overturning. Perform
imperatively this movement on a stable, flat and clear surface to support the weight of the lift.
4.7 - E
LECTRONIC VARIABLE SPEED DRIVE
The machine is equipped with 2 electronic variable speed regulators configured for each
function that manages the amount of power sent to each motor.
Do not interchange the speed controllers/regulators between machines even if they are the same model.
4001178810
HE SLOPE SENSOR IS ONLY ACTIVE WHEN THE PLATFORM IS NOT IN THE STOWED POSITION
Section B 4.1 Technical specifications).
E 10.22
Daily check
Action
USA / GB 57
A
B
.
C
D
E
F
G
H
I