Wheel/Tire Assembly; Technical Specifications; Inspection And Maintenance - Haulotte optimum 8 Operator's Manual

OPTIMUM 8 - OPTIMUM 1931 E
E
- General Specifications

4 - Wheel/Tire assembly

4.1 - T
ECHNICAL SPECIFICATIONS
Component
Reference number
Type
Size
Torque
4.2 - I
NSPECTION AND MAINTENANCE
Replace the wheels and the tires if any of the following
conditions exist :
• Presence of cracks, damage, deformation or other
faults on the hub
• Damage to the tire :
• Cut or hole > 3 cm (2 in) in the rubber side wall.
• Blister or pronounced lump on the external and lateral
wall.
• Damaged wheel stud.
• Damage or wear on the side wall to the extent that the
reinforcing wire is visible.
• Consistent wear of the ground contact surface greater
than 25%
Tires and rims are critical components for the stability of the machine. For safety reasons :
• Use only HAULOTTE® spare parts according to the technical characteristics of the machine. Refer to
the spare parts catalog.
• Do not replace factory-installed tires with tires of different specifications or ply rating.
4000415480
Solideal
Solid tires/tyres
316 mm / 108 mm (12,5 in/ 4,25 in)
115 Nm (84.81 ft lbs)
E 01.18
Standard wheel
USA / GB
A
B
C
D
E
F
G
H
I
93