Setting The Dividing Plates - Welger RP 202 CLASSIC Operating Manual

Never carry out adjustments and repairs, or maintenance and service work on the baler while it is
running. Switch off engine and remove the ignition key Wait for the baler to stop. Switch off the pto shaft and
disconnect the universal drive shaft from the pto shaft before working on the moving parts of the baler.
If maintenance or installation/assembly work is performed with the tailgate open, it is essential to secure the
tailgate to prevent it from falling.
Use the cut-off valve on the right side of the baler for this purpose. When it is in a locked state, the operating
lever is at right angles to the direction of flow (fig. 3).
The shut-off valve may only be actuated from the open right hand side guard door.
fig. 97
82

12.15. Setting the dividing plates

In order to prevent binding material from coming out of the roll
chamber, two dividing plates [1] were built into the area near the
front rollers (fig. 97). Upon loosening the fastening screws in the
side walls, the dividing plate clearance to the rollers can be set.
For correct setting, the longitudinal section of the operating
rollers should just about gently strike the dividing plates. Finally
tighten the screws once again.
WELGER RP 202 • RP 220 • RP 302 • RP 320