Ejecting The Bale - Welger RP 202 CLASSIC Operating Manual

9.3. Ejecting the bale

After completing the wrapping process, open the tailgate
hydraulically so that the bale rolls out. Keep the tractor control
valve on "raise" until the tailgate has completely opened.
If no bale ejector* (see fig. 9, No. 8) is fitted, then reverse by
approx. 3 m before ejecting and then drive forward again up to
the windrow before closing the tailgate.
To close the tailgate, keep the tractor control valve on "lower"
until the tailgate has been securely locked and when required,
until the net wrapping* is once again tensioned.
If possible move the tractor control valve into the floating
position after actuation (only if "floating position" is available).
For balers fitted with BALERCONTROL III there is also an
audible confirmation tone. The control panel display again
shows the initial start-up condition.
The tailgate is now locked on both sides and collecting the crop
can begin again for the next bale.
Take special care when opening and closing the tailgate.
Stay clear of swing area of the tailgate at all times.
If the ground is uneven, the bale may start to roll or tip over onto
its side. Employ suitable measure to eliminate this risk.
All persons must move away from the bale's possible
movement area.
WELGER RP 202 • RP 220 • RP 302 • RP 320 59