If The Cutting Device Was Used - Welger RP 202 CLASSIC Operating Manual

fig. 81
fig. 82
62
What to do if material jams:
RP 220 FARMER / RP 320 FARMER
Only rectify functional faults at inlet elements (such as
pick-up unit, augers and rotor) when the tractor engine is turned
off and the ignition key has been removed!
Cutting device: There is also a danger of injury in handling the
inlet section when the cutting device is lowered. Always wear
protective gloves!

If the cutting device was used:

1. Stop driving and switch off the pto shaft.
2. (Left machine side, fig. 81 and fig. 82:) The right ball valve
of the hydraulic block must point towards the tail of the
machine. The left ball valve of the hydraulic block must
point towards the machine.
3. Set the connected tractor control valve to „Lower" and leave
it in this position until the blades move into the bottom flap.
4. Reengage the pto shaft. The material jam is automatically
removed by the running conveying elements.
If the material jam has been removed, see work steps 5 and 6.
If swivelling-back of the cutting device is not sufficient to remove
a material jam: open and close the bottom flap (please continue
on the next page now).
5. Set the connected tractor control valve to „Raise" and leave
it in this position until the blades move to working position.
6. To enable the hydro accumulators to fill: actuate the control
valve for another 5 s. approx. after the blades have moved
in.
WELGER RP 202 • RP 220 • RP 302 • RP 320