Maintenance / Settings; Environment/Disposal; Clamping Elements - Welger RP 202 CLASSIC Operating Manual

12. Maintenance / Settings

12.1. General instructions
After about the first 20 operating hours: tighten all fastening
screws, wheel nuts, drawbar screws and nuts, including those
inside the machine. When doing so, do not change adjustment
screws, e.g. on the twine guide or the net brake.
Danger of falling! Never step on the maintenance
platform of the moving machine. Before you step on the
maintenance platform: Stop the machine, switch off power-take-
off shaft and motor engine and wait until the machine has
stopped.

12.2. Environment/Disposal

Lubricants
Always dispose of lubricants properly and do not allow them to
pollute the environment. Observe the safety data sheets of the
lubricants used. Biologically degradable lubricants must be
disposed of separately.
1 litre of oil contaminates 1 million litres of water.
1 litre of oil contaminates 10 cubic metres of soil.
Consumables
Any twines, nets, foils and machine parts thrown away are
polluting. They particularly endanger the animal world.
Therefore: Dispose of twines, nets, foils and machine parts
properly!

12.3. Clamping elements

(fig. 84) The gear wheels [2] of the main drive roller [1]
are installed on the roller end by means of clamping elements.
Any work on the clamping elements [3] may only be carried out
by instructed expert personnel.
fig. 84
WELGER RP 202 • RP 220 • RP 302 • RP 320 67