Cross Support - Welger RP 202 CLASSIC Operating Manual

WELGER RP 202 • RP 220 • RP 302 • RP 320

5.1.1. Cross Support

1. Guide twines A and B through to the guide rollers [8] as
shown in fig. 27.
2. Loop twine A anticlockwise once around the variable
diameter disc [9].
3. Finally locate each twine at the entry to their respective guide
roller.
4. Turn the guide roller by hand until the thread has been
securely grasped.
Note:
The clamping and cutting devices [10] have been factory set so
that the driving twine (shown as a continuous line ) must
be guided through the guide roller on the left-hand side, as seen
from the direction of travel.
5. Tension both sets of twine once they have been threaded.
fig. 27
A =
B =
29