Triggering The Wrapping - Balecontrol E; Manual Twine Wrapping; Manual Net Wrapping - Welger RP 202 CLASSIC Operating Manual

1741-97
fig. 71
fig. 72
WELGER RP 202 • RP 220 • RP 302 • RP 320
9.1.1. Triggering the wrapping ( BALERCONTROL E )
When the pre-selected bale density is reached, the tractor driver
is notified by the red LED [2] and the buzzer [9].
Depending on the selected wrapping mode, the wrapping is
triggered either automatically or manually from the appropriate
button (net [6] or twine [7]).

Manual twine wrapping

•
Selection: Depress button [5] several times until both yellow
LED's go out.
•
Once the pre-selected bale density is reached, the red LED
initially begins to flash and then remains continually on. The
buzzer sounds.
•
While
corresponding yellow LED flashes simultaneously.
•
Stop driving the tractor approx. 5 to 10 seconds after
depressing the twine button [7]. With normal P.T.O speed,
allow the twine to wrap the bale.
•
Check the twine is running by the detection pulleys (fig. 71).
As soon as the detection pulleys stop, the wrapping process
is finished
•
Open the tailgate and eject the bale.

Manual net wrapping

•
Selection: Depress button [5] several times until both yellow
LED's go out.
•
Once the pre-selected bale density is reached, the red LED
initially begins to flash and then remains continually on. The
buzzer sounds.
•
Stop driving the tractor and allow the pick up unit to clear.
•
Depress the net button [6] for approx. 5 seconds; The
corresponding yellow LED flashes.
•
With normal P.T.O. speed allow the net to wrap the bale
1742-44
• Check the net is running by the detection pulley (fig. 72). As
soon as the detection pulley stops the wrapping process is
finished.
•
Open the tailgate and eject the bale.
driving, depress the twine button [7]; the
51