Activating The Cutting Device; Deactivating The Cutting Device - Welger RP 202 CLASSIC Operating Manual

fig. 45
I
fig. 46
WELGER RP 202 • RP 220 • RP 302 • RP 320
RP 220 FARMER - RP 320 FARMER
with cutting unit, with swivel floor
Pick-up unit width 2.0 metres

Activating the cutting device:

1. Open the shut-off valve on the left side of the baler
2. Activate the "raise" function on the connected tractor valve
3. In order for the hydraulic accumulators to fill, continue to
4. Close the shut-off valve (fig. 45), i.e. move the lever into the

Deactivating the cutting device:

1. Open the shut-off valve on the left side of the baler (fig. 45),
2. Activate the "raise" function on the connected tractor control
3. Close the shut-off valve (fig. 45), i.e. move the lever into the
4. Activate the "raise" function on the connected tractor control
0
0387.67.00.00
Tip:
In order to ensure free movement of the individual blades, move
the cutting device in and out several times each day.
The shut-off valve (fig. 45) is only opened for moving the blades
in and out.
During normal operation the shut-off valve must always remain
closed (position "0" in fig. 46).
(fig. 45), i.e. move the lever into the vertical position.
until the cutting device moves into its working position.
(If the swivel floor (HYDROFLEXCONTROL) was open, it
will also move upwards.
activate the control valve for another 5 seconds after the
cutter blades have moved in.
horizontal position.
i.e. move the lever into the vertical position.
valve for about 5 seconds. Blades and conveyor channel
floor will move downwards one after the other.
horizontal position.
valve until the conveyor channel floor is completely closed.
37