The Machine Does Not Print - Ricoh 2015 General Settings Manual

The Machine Does Not Print

Possible Cause
Is the power on?
Is the machine online?
Does the printer function
status indicator stay red?
Is there a warning status or
error message on the dis-
play?
Can you print a configura-
tion page?
Is the interface cable con-
nected securely to the ma-
chine and computer?
Are you using the correct
interface cable?
Was the interface cable
connected after the ma-
chine was turned on?
Is the signal status satisfac-
tory when using wireless
LAN in infrastructure
mode ?
When using wireless LAN,
is the SSID correctly set?
When using wireless LAN,
is the access point correctly
set?
Check the cable is securely plugged into the power outlet and the
machine.
Turn on the main power switch.
If not, press { { { { f f Online} } } } on the control panel.
f f
If so, check the error message on the display and take required ac-
tion.
If so, check the error message or warning status on the display and
take the required action.
If you cannot print a configuration page, there maybe a machine
malfunction. Contact your sales or service representative.
See p.26 "Printing the configuration page" for printing a configu-
ration page.
Connect the interface cable securely. If it has a fastener, fasten that
securely as well.
See "Connecting the Machine", Printer Reference 1.
The type of interface cable you should use depends on the compu-
ter. Be sure to use the correct one. If the cable is damaged or worn,
replace it.
See "Connecting the Machine", Printer Reference 1.
Connect the interface cable before turning on the machine.
To check signal status, press the { { { { User Tools/Counter} } } } key, and then
select [System Settings] using { { { { U U U U } } } } or { { { { T T T T } } } } . On the [Interface Settings],
select [IEEE802.11b], and then select [Wireless LAN Signal] using
{ { { { U U U U } } } } or { { { { T T T T } } } } . If signal quality is poor, remove objects that might
cause interference.
Note
❒ You can check signal status only when using wireless LAN in
infrastructure mode.
Check using the machine's control panel that the SSID is correctly
set.
See "Interface Settings/IEEE 802.11b (Option)", Network Guide.
Check access point settings when in infrastructure mode. Depend-
ing on the access point, client access may be limited by MAC ad-
dress.
Also, check there are no problems in transmission between access
point and wired clients, and between access point and wireless cli-
ents.
The Machine Does Not Print
Solutions
2
15