Ricoh 2015 General Settings Manual page 711

SMB
Use the "smb" command to configure
or delete the NetBEUI settings such as
the computer name or workgroup
name.
msh> smb parameter
Parameter Settings
comp Your computer name consist-
ing of up to 15 characters
group Workgroup name consisting
of up to 15 characters
comment Comment consisting of up to
31 characters
notif {on | You can enable or disable no-
off} tification of print job comple-
tion.
clear comp Clears the computer name
clear group Clears the Workgroup name
clear com- Clears comment
ment
Note
❒ You cannot use a computer name
starting with "RNP" or "rnp".
ROUTE
Use the "route" command to control
the routing table.
This command allows you to config-
ure and display routing information.
You can change the network configu-
ration from remote computers using
this command.
Note
❒ The maximum number of routing
tables is 16.
Remote Maintenance by telnet
Commands Topics of setting
route add Adds a host/network route
{host | net} to "destination", and a gate-
destination way address to "gateway" in
*1
gateway the table. Host becomes the
*1
default.
route de- Deletes a host/network route
lete {host | from the table. Host becomes
net} desti- the default.
*1
nation
route get Displays only route informa-
{destina- tion corresponding to a spec-
*1
tion } ified destination. When the
destination is unspecified, all
routing information is dis-
played.
route active You can turn the specified
{host | net} destination on or off. Host be-
destination comes the default.
*1
on/off
route add You can set the default gate-
default way address.
*1
gateway
route flush Deletes all routing informa-
tion.
*1
IP address
SLP
Use the "slp" command to configure
SLP settings.
You can search the NetWare server us-
ing SLP in the PureIP environment of
NetWare5/5.1, 6. Use the "slp" com-
mand to configure the value of TTL
used by the SLP multi-cast-packet.
Note
❒ The default value of TTL is "1". A
search is executed only within a lo-
cal segment. If the router does not
support multi-cast, the settings are
not available even if the TTL value
is increased.
❒ The acceptable TTL value is 1 - 255.
msh> slp ttl {1 - 255}
9
89