Broadcasting Sequence - Ricoh 2015 General Settings Manual

Faxing
F F F F
Specify a destination.
2
Note
❒ Press [
tination between fax number
and e-mail address.
❒ If you want to specify another
destination, repeat steps
F
.
❒ Entered destinations can be
checked using { { { { U U U U } } } } or { { { { T T T T } } } } .
❒ To delete an entered destina-
tion, find it using { { { { U U U U } } } } or { { { { T T T T } } } } ,
press the { { { { Clear/Stop} } } } key, and
then press [Delete].
G G G G
Press the { { { { Start} } } } key.
Note
❒ Do not lift the ADF or ARDF
during scanning.
After scanning, the standby dis-
play appears.
- Sending originals using the -
- -
exposure glass
A
Make sure that Memory Trans. in-
dicator lights. If it is not, press the
{ { { { Transmission Mode} } } } key.
B
Place the first page of your original
face down on the exposure glass.
C Specify a destination.
D Make the scan settings you re-
quire.
Press the { { { { Start} } } } key.
E
The machine starts scanning.
18
] to switch the des-
E
and
F
Place the next original on the expo-
sure glass within 60 seconds after
the machine has finished scanning
the first original.
Repeat steps D to F for all origi-
G
nals.
H
Place the last original, press the
{ { { { Start} } } } key, and then press the
{ { { { # # } } } } key. # #

- Broadcasting Sequence

-
- -
If you dial several destinations for the
same message (broadcasting), the
messages are sent in the order in
which they were dialed. If the fax
message could not be transmitted, the
machine redials that destination after
the last destination specified for
broadcasting. For example, if you
specify four destinations, A through
D, for broadcasting, and if the lines to
destinations A and C are busy, the
machine dials the destinations in the
following order: A, B, C, D, A, and C.
- Checking the Transmission -
- -
Progress
To check which destinations the fax
message has been sent to so far, print
the Journal. See p.21 "Printing the
Journal", Facsimile Reference <Ad-
vanced Features> .