Konica Minolta bizhub 1250 User Manual page 176

5.12 [Saddle Stitcher Adjustment] - [Crease Position Adjustment]
5
Load the paper size selected in step 3 into the tray, then select that tray key.
6
Press Start on the control panel. A sample pattern will be output.
7
Check the misalignment between the fold and crease of the output sheet.
8
Exit the print mode to return to the PB Cover Crease Position Adjustment Screen.
% In bizhub PRESS 1250/1250P/1052, press [Close].
% In bizhub PRESS C1070/C1070P/C1060/C71hc or bizhub PRESS C1100/C1085, press [Exit
PrintMode].
9
If adjustment is required, select [Crease Line 1] or [Crease Line 2] and use the touch panel keypad or
control panel keypad to enter the setting data.
% Adjustable range: -20 (To shorten) to +20 (To lengthen) (1 step = 0.1 mm)
% Use [+<->-] to specify the value to be positive or negative.
% Adjust the distance between the paper edge in the top side of the perfect bind cover and the crease
position.
10
Press [Set] to change the current data.
11
Repeat the steps from 4 to 10 until the desired result is obtained.
12
Press [Return] to restore the Crease Position Adjustment Menu Screen.
Saddle Stitcher SD-513
5
5-47