Page 1
1216 Frequently Asked Questions This document contains information that was extracted from Konica’s Expert Support knowledge base. Legal Notice Konica recommends that all service be performed by an authorized service representative. USERS AGREE THAT USE OF THIS DOCUMENT IS AT USER’S SOLE RISK AND THAT THIS DOCUMENT IS...
Page 2
1216 FAQ DESCRIPTION: How to clear fuser abnormality codes (F34, F35, F36). RESOLUTION: To reset fuser codes, perform the following steps: 1. Access the 25 mode (power the machine OFF. Hold down the 2 and 5 keys, and power the machine ON).
Page 3
1216 FAQ DESCRIPTION: How to enable auto tray switching (ATS). RESOLUTION: To enable the auto tray switching feature, perform the following: 1. Power OFF the main power switch. 2. Press and hold the 2 and the 5 number keys and turn the main power switch ON.
Page 4
7. Power the copier OFF/ON to exit the 25 mode. DESCRIPTION: How to program ECM passcodes. RESOLUTION: The 1216 does not have ECM passcode capability. DESCRIPTION: PLEASE LOAD PAPER indication when trying to feed from the drawer base after setup or installation.
Page 6
1216 FAQ DESCRIPTION: How to install a Konica key counter. RESOLUTION: Open the bypass tray door, on the lower right side on the main body there is a plate. Remove the plate, disconnect the connector and connect the key counter to the main body connector.