C060: Firmware Update Error (Only For Magicolor 5450); C062: Hold Job Error/No Tray 3 (Only For Magicolor 5450) C063: Hold Job Error/No Tray 4 (Only For Magicolor 5450) C064: Hold Job Error/No Memory (Only For Magicolor 5450) - Konica Minolta magicolor 5430 DL Service Manual

Main Unit Field Service
2.4.26

C060: Firmware Update error (Only for magicolor 5450)

Print Control Board (PWB-P)
Step
Turn OFF the Power Switch of the printer and
1
turn it ON again (Restart of the printer.)
Check the cable that has been used for update of
2 the firmware for proper connection and correct as
necessary.
3 Update the firmware again.
Check the PWB-P connector for proper connec-
4
tion and correct as necessary.
5 Change PWB-P
2.4.27 C061: Hold job error/No Duplex unit (Only for magicolor 5450)
C062: Hold job error/No Tray 3 (Only for magicolor 5450)
C063: Hold job error/No Tray 4 (Only for magicolor 5450)
C064: Hold job error/No Memory (Only for magicolor 5450)
Print Control Board (PWB-P)
Step
Turn OFF the Power Switch of the printer and
1
turn it ON again (Restart of the printer.)
Return to the same state as the device configura-
2
tion when job was held.
Check the options that are mounted on the
3 printer for proper connection and correct as nec-
essary.
Check the PWB-A connector for proper connec-
4
tion and correct as necessary.
5 Delete the job hold in "PROOF/PRINT MENU."
Relevant Electrical Parts
Action
Relevant Electrical Parts
Mechanical Control Board (PWB-A)
Action
4-25
Malfunction code
WIRING DIAGRAM
Location
Control Signal (Electrical
Component)
-
-
-
-
-
WIRING DIAGRAM
Location
Control Signal (Electrical
Component)
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-