Konica Minolta bizhub 1250 User Manual page 86

4.9 Performing 2-Side Slitting on Fold & Stapled/Multi Half-Folded Paper
Setting item
[Fold&Staple]
(+ [Fore-edge Trim-
ming])
Fold & Staple Set-
ting [2-Side Slitting]
to be set to [ON]
For Booklet in Ap-
plication, select
[Cover With Copy
Sheet] or [Cover
With Blank Sheet].
or
[Multi Half] (+ [Fore-
edge Trimming])
Fold & Staple Set-
ting
[2-Side Slitting] to
be set to [ON]
For Booklet in Ap-
plication, select
[Cover With Copy
Sheet] or [Cover
With Blank Sheet].
NOTICE
Slitting can be specified within the range from 8.0 mm to 26.0 mm in increments of 0.1 mm.
The difference of specified 2-side slitting between the two sides must be within 10.0 mm.
[Offset against Cover] is enabled when [Cover With Copy Sheet] or [Cover With Blank Sheet] is selected for
Booklet in Application. Slitting of body relative to cover can be specified within the range from -1.0 mm
to +1.0 mm in increments of 0.1 mm.
NOTICE
The multi half-folded and stapled sets will be delivered onto the bundle exit tray. Set up the bundle exit tray
extension, and follow the preparation process before opening the stopper. Failing to carry out the prepara-
tion may lead to output sheets falling off the bundle exit tray. It could also cause the sensor to fail to detect
the output full condition.
d
Reference
Please check paper information before use. See "Paper Information" (page 2-12) for details.
Saddle Stitcher SD-513
Details
Select [All Sheets] for
"2-Side Slitting" to per-
form 2-side slitting on
cover and body.
Select [Cover Only] for
"2-Side Slitting" to per-
form 2-side slitting on
cover only.
Illustration
4
4-49