Adding A Power Module - Gamatronic POWER PLUS Technical Manual

Gamatronic Electronic Industries Ltd.
11.3

ADDING A POWER MODULE

If an additional shelf is attached at the top of the system, the DIP switch of the Control PCB
must be changed to the next address code as shown in Table 3-3 on page 38.
Updating the number of modules in the Power Plus processor:
('Ent' represents a press of the Ent key.)
Ent, Setup,
Ent, Password (default password is 8 "left arrows" [ ] ),
Ent, Service ,
Ent, Configure
The system reinititializes itself.
11.3.1.1 T
URNING OFF THE OUTPUT CURRENT LIMIT
Ent, Setup,
Ent, Password (default password is 8 "left arrows" [ ] ),
Ent, Battery,
Power+ Technical Guide
Ent, Total # of UPS,
Ent, (enter number of UPSs),
Ent , Ent
Ent, Current Limit,
Ent, Enable current limit (off)
Esc.
:
87